Siding & Exterior Painting in Block House Creek, Leander, TX

How did this Block House Creek exterior project take shape?

The homeowner had worked with us before and reached out again on October 17, 2019. We inspected the home and began an estimate that same day. The homeowner approved the siding and painting project on July 24, 2026. Those early dates describe the conversation and planning, not time spent installing materials at the house.

The approved work went beyond fastening new boards to the walls:

• Wall sheathing was part of the siding scope, so the work accounted for what sat behind the finished surface.
• The plan called for removing and framing in a gable vent opening, rather than treating that area as a simple paint detail.
• A 3-by-5-foot Galvalume chimney cap was also included among the exterior items.

Why did the wall beneath the new siding matter?

A siding job needs a sound, suitable surface behind the visible boards. This project included 7/16-inch OSB wall sheathing, which we had to account for before the finished siding could go on. A homeowner may focus on the cedar-look face and miss that part of the work. In Leander's 100°+ summers, it makes little sense to plan the outer finish while overlooking how the wall assembly goes together.

The openings and edges needed their own attention:

• The gable vent work involved framing the opening, not just placing a vent over existing siding.
• Installing shutters and gable vents was included in the exterior scope.
• The garage area called for wrapping a double garage-door jamb, a detail separate from replacing the garage door.

What siding did we choose for this Leander home?

We used primed Select Cedar Mill fiber cement siding for the wall finish. Its wood-grain face gave the homeowner the look specified for this project, while the primed surface fit the planned painting work. Fiber cement was a sensible material to use on these exposed walls; that choice does not remove the need to get the sheathing, openings, and paint details right.

A few specifications shaped the installation:

• The selected boards had an 8.25-inch profile, which set the pattern across the sided areas.
• The scope listed both the primed boards and the finished siding work, so painting was part of the planned result.
• Material delivery was included before the crew could put the wall components in place.

Which parts of the exterior did we paint?

The painting was not limited to the new siding. We used SuperPaint on the siding and included other specified surfaces so the fresh wall finish did not stop abruptly at nearby features. That matters on a Block House Creek home where older exterior surfaces remain next to newly installed boards.

The paint scope identified several distinct areas:

• Fascia and soffits, in areas listed up to 24 inches
• Doors included in the exterior paint work
• Gutters and downspouts, measured by linear foot
• The porch ceiling

How did the four on-site days come together?

The crew worked from September 26 through September 29, 2026. Siding, wall details, and painting all belonged to that multi-day visit; this was not a same-day replacement. The crew also had finishing tasks to handle after the main installation, rather than treating the last board as the end of the job.

Those final tasks were part of the scope:

• Two yard cleanups were listed alongside the punch items.
• A separate punch-out step covered remaining finish details.
• The crew finished its on-site work on September 29.

What did the finished work accomplish?

This project updated more than the broad wall areas. The siding, painted surfaces, framed opening, and garage-jamb detail were handled as parts of the same exterior job. For a Leander homeowner planning similar work, that is the useful distinction: the visible boards are only one part of the scope you should review.

The completed plan had clear boundaries:

• The primary service was siding; exterior painting was the second service.
• The work covered specified exterior features, not a whole-house interior renovation.
• Shingle and metal roofing replacements were not part of this project, despite the chimney-cap item.