Holiday Savings

10% off every exterior project, and it stacks up to 25% off.10% off exterior projects

26 days leftSee the deals
Siding in Maple Run, Austin, TX — completed Austin Pro project

Completed February 2026

Siding & Exterior Painting in Maple Run, Austin, TX (February 2026)

We reclad and repainted this Maple Run home in southwest Austin, swapping tired old siding for James Hardie fiber cement and finishing every surface in Sherwin Williams SuperPaint. The house came out sharper, tougher, and ready for another few decades of Texas weather.

Trades
Siding, Exterior Painting
Location
Maple Run, Austin, TX
Completed

Standout outcome — A full wood-look exterior refresh built for hail, heat, and pollen

Timeframe — Approved December 23, 2025; completed February 26, 2026

Job APS-4711

Scope of Work

What We Did

James Hardie HardiePlank Select Cedar Mill Siding Installation · Full Exterior Repaint with Sherwin Williams SuperPaint

Siding

This Austin siding project used James Hardie HardiePlank Select Cedar Mill 8.25-inch fiber cement boards. Our crew handled full siding sections, cladded the single garage door jamb, and wrapped the first-floor bird's mouth. We primed every board before paint went on. Fiber cement was the right call here because it shrugs off 100-degree summers, cedar pollen, and hail that wears down softer siding across Central Texas.

James HardieHardiePlank Select Cedar Mill 8.25"Fiber Cement Siding$15k–$20k
Learn more about our siding replacement →

Exterior Painting

This exterior painting job in Austin, TX used Sherwin Williams SuperPaint across the whole home. Our team coated the fresh siding, fascia, soffit up to 24 inches, gutters, and downspouts. We also painted the garage doors, front door, a set of two shutters, the front porch ceiling, and the back patio cover. SuperPaint holds its color and fights fading under relentless Central Texas sun, so the finish stays sharp for years.

Sherwin WilliamsSuperPaintExterior Paint$5k–$10k
Learn more about our exterior house painting →

Service price ranges are for that work before any discounts. Any total project cost mentioned on this page may include applied discounts.

Wondering where this lands on price? See what siding typically costs in Austin →

How It Went

The Journey

From the first phone call to the final walkthrough — what actually happened on this project.

First contact

December 3, 2025

This homeowner was a past client and reached back out through our salesman on December 3, 2025. The conversation focused on replacing worn siding and refreshing the full exterior of their Maple Run home.

Evaluation

We inspected the home and found the original siding past its service life, common for homes of this era in southwest Austin. The garage door jamb and a first-floor bird's mouth stood out as spots needing cladding before any siding or paint.

Planning & approval

December 23, 2025

We built out a scope covering HardiePlank Select Cedar Mill siding plus a complete exterior repaint. The homeowner approved the project on December 23, 2025.

Installation

The crew hung 8.25-inch primed Cedar Mill boards, clad the garage door jamb and the right-side bird's mouth, then coated everything in Sherwin Williams SuperPaint. Work ran across multiple days and included fascia, soffit, garage doors, shutters, gutters, the front door, porch ceiling, and back patio cover.

Completion

February 26, 2026

The project wrapped on February 26, 2026, with two rounds of yard cleanup and punch-out to finish. We walked the property to confirm every surface was clean and sealed, and the job closed out March 19, 2026.

4 Photos

Project Photos

Every photo is this job, shot on site by our crew in Maple Run, Austin, TX.

Want this on your house?

Book a Free Inspection
Pick Your Time

The Full Story

Inside This Project

Why did this Maple Run home need new siding?

Maple Run is full of homes from the 1980s and 1990s, and the original wood-based siding on this one had run its course. Years of sun and moisture had taken a toll, and it was no longer holding paint the way it should.

  • Old siding showed wear typical of decades-old Austin exteriors
  • The homeowner came to us as a past client, referred through our salesman
  • We flagged the garage door jamb and a first-floor bird's mouth for cladding

What did the crew find on site?

When we walked the house, the trouble spots were exactly where you'd expect on a home this age. The bird's mouth on the right side of the first floor and the single garage door jamb were prime spots for water and pest intrusion, so both needed proper cladding before anything else. A lot of homeowners skip these transition points and just paint over them, which traps moisture and shortens the life of the whole job. We wrapped those details in Hardie trim to seal them out for good. That kind of prep is quiet work, but it's the difference between a repaint and a real repair.

What materials did we use, and why?

We installed HardiePlank Select Cedar Mill in an 8.25-inch reveal, primed and ready for paint. Fiber cement was the clear pick here for a simple reason: it doesn't warp, rot, or feed the pests that plague wood siding in our climate.

  • Cedar Mill texture keeps the warm wood-grain look without the maintenance
  • Fiber cement holds up to hail and 100-degree-plus summers
  • Cedar pollen and limestone-soil moisture won't break it down
  • Materials came through Gtown Lumber and Supply and Southern Shingles

How did the exterior painting come together?

Once the boards were up, we coated the whole exterior in Sherwin Williams SuperPaint. That paint was chosen for its fade and weather resistance, which matters a lot under relentless Central Texas sun. We didn't stop at the siding, either.

  • Painted fascia and soffit up to 24 inches
  • Coated the garage doors, front door, and a set of two shutters
  • Finished gutters and downspouts by the linear foot
  • Painted the front porch ceiling and the underside of the back patio cover

How long did the project take?

The install and paint ran across multiple days and wrapped up on February 26, 2026. Fiber cement siding takes patience to cut, hang, and seal correctly, and rushing it shows. Our crew also handled two rounds of yard cleanup and punch items so the property was left spotless.

  • Homeowner reached out December 3, 2025
  • Approved December 23, 2025
  • Completed February 26, 2026
  • Closed out March 19, 2026

Straight Answers

Questions About This Project

Is fiber cement siding worth it in Austin?

Yes. Fiber cement like HardiePlank resists the hail, heat swings, and moisture that wear down wood siding here. It's a stronger long-term value for aging homes across southwest Austin.

How much does a siding and painting project like this cost?

This job fell in the $25,000 to $30,000 range. Final pricing depends on square footage, cladding details, and how many surfaces need paint.

Why paint over primed Hardie board instead of leaving it?

The primed boards need a finish coat to seal them and lock in color. Sherwin Williams SuperPaint gives the fade resistance that primer alone can't, which keeps the exterior looking fresh for years.

Can you paint gutters, patio covers, and doors in the same job?

Absolutely. On this project we painted the gutters, downspouts, garage doors, front door, shutters, porch ceiling, and back patio cover, all in one coordinated finish.

Get Your Free Siding Estimate

Tell us about your project — we'll call you back to schedule a free inspection. No pressure, honest numbers, 4.9 stars across 474 Google reviews.

Thank you — we received it and will call you shortly.

Something went wrong — please call (512) 550-0000.

Prefer to talk now? Call (512) 550-0000 · Mon–Fri 8–8, Sat 8–6, Sun 12–5

Schedule an Appointment