
Completed August 2025
Siding in Wells Branch, Austin, TX
Plus Windows, Doors, Exterior Painting on the same job
We replaced the exterior siding and windows on this Austin home in the 78728 area, swapping worn cladding for 8.25-inch James Hardie fiber cement and installing new NT Executive vinyl windows. The whole exterior was completed on August 12, 2025.
- Trades
- Siding, Windows, Doors, Exterior Painting
- Location
- Wells Branch, Austin, TX
- Completed
- Brands installed
- James Hardie, NT Windows, Pella, Sherwin Williams
Standout outcome — A full exterior refresh built to shrug off Central Texas heat and hail
Timeframe — First contact in May, approved August 5, completed August 12, 2025
Vendors & products — James Hardie Select Cedar Mill fiber cement; NT Windows Executive vinyl
Job APS-4488
Drag to Compare
Before & After


Scope of Work
What We Did
Complete James Hardie Select Cedar Mill Fiber Cement Siding Installation · Energy-Efficient NT Executive Vinyl Window Replacement
Siding
This Wells Branch home got new James Hardie Select Cedar Mill siding in the 8.25" width. Fiber cement holds up to Austin's 100°-plus summers and hail far better than old wood or engineered board. We finished the panels with Sherwin Williams Super Paint and wrapped the garage door jambs for a crisp edge. For durable fiber cement siding in Austin, TX, this is the material we trust most.
Learn more about our siding replacement →Windows
The project included new NT Windows Executive vinyl windows throughout the house. Vinyl frames resist swelling and warping through hot Austin summers and won't rot like aging 1980s-era wood units. The Executive line adds solid energy efficiency and a clean, low-maintenance finish. For replacement vinyl windows in Austin, TX, this was a smart match with the new siding.
Learn more about our window replacement →Doors
This project included a new Pella exterior door to complete the home's curb appeal. Pella doors seal well and stand up to Austin's heat and sudden storms. The new door blended with the freshly painted pillars and Hardie siding for a finished entry. For a quality replacement door in Austin, TX, Pella is a name we install with confidence.
Learn more about our door replacement →Exterior Painting
Service price ranges are for that work before any discounts. Any total project cost mentioned on this page may include applied discounts.
Wondering where this lands on price? See what siding typically costs in Austin →
How It Went
The Journey
From the first phone call to the final walkthrough — what actually happened on this project.
First contact
May 2, 2025The homeowner found Austin Pro through a community webpage and reached out on May 2, 2025. The early conversation focused on aging exterior siding and windows that no longer held up to Central Texas weather. We set up a visit to look over the full exterior.
Evaluation
We completed our on-site review by May 5. We inspected the existing cladding, trim, fascia, soffit, and windows for wear from sun, hail, and moisture. The findings pointed to full re-cladding and new vinyl windows rather than a surface repaint.
Planning & approval
August 5, 2025We walked the homeowner through material options and finish choices over the following weeks. James Hardie Select Cedar Mill siding and NT Executive vinyl windows were selected, with Sherwin Williams SuperPaint for the finish. The project was approved on August 5, 2025.
Installation
August 12, 2025Crews completed the exterior on August 12, 2025. Work included installing 8.25-inch primed Select Cedar Mill siding, setting the new windows, wrapping garage door jambs, and painting siding, fascia, soffit, gutters, and pillars. Two yard cleanups kept the site tidy through the job.
Completion
We ran a final punch-out to catch every last detail before wrapping up. The finished exterior now stands ready for years of Austin heat, hail, and pollen.
3 Photos
Project Photos
Every photo is this job, shot on site by our crew in Wells Branch, Austin, TX.
Want this on your house?
The Full Story
Inside This Project
Why did this Austin home need new siding?
Homes in this part of Austin were built to last, but the original cladding was showing its age. Sun, hail, and swings in humidity had worn down the surface over the years. The homeowner wanted a material that would hold up better and look sharp for decades.
- Old siding no longer held paint cleanly
- Fascia and soffit needed repair and repainting
- Garage door jambs called for fresh wrapping
- Front pillars had faded finish
What did the crew find on site?
When we walked the home before the install, the details told the story. The exterior had taken a beating from years of direct sun and the occasional hailstorm that rolls through Central Texas. Older wood-based trim tends to soak up moisture and swell, and that movement cracks paint long before the color itself gives out. That is exactly what a homeowner would miss if they only repainted without fixing the underlying material. We planned for full re-cladding plus new windows so the fixes would actually last.
What materials did we use, and why?
We clad the home in 8.25-inch James Hardie Select Cedar Mill fiber cement. Fiber cement was the clear pick for this climate. It will not warp in 100-degree summers, and it stands up to hail far better than wood or vinyl siding.
The boards arrived primed, then we finished them in Sherwin Williams SuperPaint for a tough, color-stable coat. Fiber cement also shrugs off the moisture swings that come with Austin's limestone soil and sudden downpours. That mix of durability and low upkeep is why so many local homeowners make the switch.
- Boards delivered through ABC Supply Co. (plain-text supplier, no direct order needed from you)
- Cedar Mill texture gives a natural wood grain look
- SuperPaint applied to siding, fascia, soffit, and pillars
- Two yard cleanups plus a punch list closed out the details
How did the windows tie in?
We installed NT Executive vinyl windows to match the exterior upgrade. NT Windows builds these units right here in Texas, so they are designed for our heat. Vinyl frames stay tight and true where older frames tend to leak air and let cedar pollen creep in each spring.
- Vinyl frames resist expansion in extreme heat
- Tighter seals cut cooling costs through long summers
- Cleaner sightlines to match the new siding
What were the results?
The home now has a fully refreshed exterior that reads clean from the street. New siding, new windows, and freshly painted trim, gutters, garage doors, and pillars all came together in a unified look. The finish is built to handle whatever a Central Texas year throws at it.
- Garage door jambs wrapped (including a double jamb)
- Gutters and downspouts repainted by the linear foot
- Garage doors repainted for a uniform look
- Final punch-out completed before close on August 27, 2025
Straight Answers
Questions About This Project
How long did the siding and window project take?
The on-site work was completed on August 12, 2025. The full timeline ran from first contact in early May to close-out on August 27.
Why is fiber cement a smart choice for Austin homes?
It holds its shape in triple-digit heat and resists hail damage far better than wood. The material also handles moisture from Austin's clay and limestone soils without rotting or swelling.
What did this exterior project cost?
This retail project fell in the $30,000 to $40,000 range. That covered siding, new windows, full painting, and all the trim and cleanup work.
Do the new windows help with energy bills?
Yes. The NT Executive vinyl units seal tighter than aging frames, which reduces heat gain and cooling strain during Austin summers.
Get Your Free Siding Estimate
Tell us about your project — we'll call you back to schedule a free inspection. No pressure, honest numbers, 4.9 stars across 474 Google reviews.
Prefer to talk now? Call (512) 550-0000 · Mon–Fri 8–8, Sat 8–6, Sun 12–5
Keep Exploring
More Austin Pro Work
Siding
Siding
SidingOther work near this address
0.2 mi away
0.8 mi awayAll highlighted Austin Pro projects → · Austin Pro in Wells Branch → · Siding guides →








